4 Simple Steps
Follow these steps at the end of each frying day.
Add Purimax
Bring the oil to approximately 350°F. Add the correct daily amount of Purimax directly to the oil.
Mix Thoroughly
Stir Purimax into the oil for approximately 5–10 seconds, making sure the powder is evenly distributed throughout the fryer.
Begin Filtration
Begin your normal filtration cycle. Keep the oil circulating continuously so the fryer drains into the filter system while the filtered oil is returned to the fryer in a continuous loop.
Circulate for at least 2 minutes, or longer if your normal filtration procedure typically runs for a longer period. The longer the better results.
Return the Oil
Once the oil has circulated for at least 2 minutes, or for your normal longer circulation time, close the drain to stop the continuous loop.
Then pump the remaining filtered oil back into the fryer and resume normal operation.
Mid-Day Filtration
If you normally perform a mid-day filtration, you may leave the Purimax powder on the filter paper from the previous night and use that same filter during the next day’s mid-day filtration cycle.
Replace the filter paper afterward according to your normal schedule.
Before Starting Your Trial
Review the trial guide and important reminders to make sure you get the most accurate results from Purimax.